Equipment Adapters

For Magnetic Particle Inspection

Make sure your Magnaflux magnetic bench works with every part you need to inspect with this range of equipment adapters. From large, heavy parts to small pieces like bolts, screws, and pins, Magnaflux equipment adapters help you get more out of your magnetic bench by helping you make it work for a wide variety of parts.

Description

Part Numbers

Product Name	Description	Part Numbers
Central Conductors	Solid copper rods 15.875 in / 40 cm long for circular magnetization (head shot) of rings and hollow parts. Set of three diameters: 0.50 in / 12.7 mm, 0.75 in / 19.0 mm, 1.00 in / 25.4 mm	622639
Steady Rests	Used to support and stabilize long or heavy parts such as crankshafts during the inspection process.	Headstock: 605750 Tailstock: 621658 Rail-Mount: 1857
Contact Block	Permits remote testing of parts that are too heavy or too large for processing on unit. When clamped between head and tailstock, the block supplies magnetizing current to remote prods or clamps through flexible cable (cable not included, see cables and connectors).	1830
Small Parts Adapters	Permit the use of standard wet horizontal test units for inspection of small parts such as bolts, screws, pins, etc. Mounted directly to either the head (PN 28470) or tail stock (PN 28471) the solid copper adaptors maintain adequate clearance to proper clamping action.	Headstock: 28470 Tailstock: 28471
Flat Magnetic Coil	For non-contact magnetic particle inspection of small parts such as fasteners and ring-like parts. Can be used with any magnetic particle unit or power pack to allow for quick, easy processing of several small parts at one time.	611700